Dimensions
Dimensions (H x W x D)
2.09" x 11.65" x 9.02" (53 x 296 x 229 mm)
Weight
-
Amplifier
Amplifier Class
Class D
Channels
2
Amplifier Power
Rated Continuous (RMS) Power (14.4 V input @ 4 Ohm < 1% THD)
65 W x 2/200 W x 1 (Bridged)
Rated Continuous (RMS) Power (14.4 V input @ 2 Ohm < 1% THD)
100 W x 2
Amplifier Processing
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio (Manufacturer Rating)
> 95 dB
Damping Factor @ 4 Ω
> 200
Damping Factor @ 2 Ω
-
THD+N @ rated power
0.05%
Frequency Response (+0, -1dB)
-
Input Voltage Range @ RCA Inputs
300 mV-8 V
Input Impedance
20 kΩ
Remote Level Control
-
Remote Level Modes
-
Channel Input Mode Switch
-
Pass-through Preamp Output
-
Source Channel Selection for PreOuts
-
Amplifier Filters
Bass Boost EQ
0 to +18 dB @ 45 Hz
Output Polarity Switch
-
Filter Mode(s) Channels 1 & 2
Low-Pass or High-Pass
Filter Slope(s) Channels 1 & 2
Low-Pass: 18 dB/octave; High-Pass: 12 dB/octave
Filter Frequency Range Channels 1 & 2
Low-Pass: 40 Hz-160 Hz; High-Pass: 40 Hz-600 Hz
High-Pass/Low-Pass Full Range Filter
-
HP Variable Crossover Frequency Range
-
LP Variable Crossover Frequency Range
-
Infrasonic Filter
20 Hz-55 Hz, 18 dB/octave
Detented, Calibrated Filter Potentiometers
-
Electrical
Operating Voltage
10-16 VDC
Current Consumption (idle)
-
Current Consumption (standby)
-
Fuse Rating
1 x 25 A
Recommended Fuse Type(s)
-
Minimum Copper Power/Ground Wire Gauge
4 AWG
General
Water/Dust Protection Rating
-
Operating Temperature Range
-
Protection Circuits
-
Warranty/Certifications
Certifications
-
Warranty
-