Dimensions
Dimensions (H x W x D)
-
Weight
-
Amplifier
Amplifier Class
Class D
Channels
1
Amplifier Power
Rated Continuous (RMS) Power (14.4 V input @ 4 Ohm < 1% THD)
300 W x 1
Rated Continuous (RMS) Power (14.4 V input @ 2 Ohm < 1% THD)
600 W x 1
Rated Continuous (RMS) Power (14.4 V input @ 1 Ohm < 1% THD)
800 W x 1
Rated Continuous (RMS) Power (12.5 V input @ 4 Ohm < 1% THD)
-
Rated Continuous (RMS) Power (12.5 V input @ 2 Ohm < 1% THD)
-
Amplifier Processing
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
> 95 dB
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
75 dB
Signal-to-Noise Ratio (Manufacturer Rating)
-
Damping Factor @ 4 Ω
-
Damping Factor @ 2 Ω
-
THD+N @ rated power
-
Frequency Response (+0, -1dB)
25 Hz-200 Hz
Input Voltage Range @ RCA Inputs
125 mV-5 V (low level); 250 mV-10 V (high level)
Input Impedance
-
Remote Level Control
-
Remote Level Modes
-
Channel Input Mode Switch
-
Pass-through Preamp Output
-
Source Channel Selection for PreOuts
-
Amplifier Filters
Bass Boost EQ
0 to +6 dB @ 40 Hz
Output Polarity Switch
-
Filter Mode(s) Subwoofer Channel
Low-Pass
Filter Slope(s) Subwoofer Channel
12 dB/octave
Filter Frequency Range Subwoofer Channel
50 Hz-200 Hz
High-Pass/Low-Pass Full Range Filter
-
HP Variable Crossover Frequency Range
-
LP Variable Crossover Frequency Range
-
Infrasonic Filter
25 Hz fixed, 24 dB/octave
Detented, Calibrated Filter Potentiometers
-
Electrical
Operating Voltage
-
Current Consumption (idle)
< 3 A (remote on)
Current Consumption (standby)
< 2 mA (remote off)
Fuse Rating
-
Recommended Fuse Type(s)
-
Minimum Copper Power/Ground Wire Gauge
-
General
Water/Dust Protection Rating
-
Operating Temperature Range
-
Protection Circuits
-
Warranty/Certifications
Certifications
-
Warranty
3 Years