Dimensions
Dimensions (H x W x D)
2.24" x 16.54" x 8.27" (57 x 420 x 210 mm)
Weight
11.35 lbs (5.15 kg)
Amplifier
Amplifier Class
Class D
Channels
6
Amplifier Power
Rated Continuous (RMS) Power (Manufacturer Rating @ 4 Ohm)
100 W x 6/280 W x 3 (Bridged)
Rated Continuous (RMS) Power (Manufacturer Rating @ 2 Ohm)
140 W x 6
Amplifier Processing
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio (Manufacturer Rating)
-
Damping Factor @ 4 Ω
-
Damping Factor @ 2 Ω
-
THD+N @ rated power
-
Frequency Response (+0, -1dB)
10 Hz-40 kHz (-3 dB)
Input Voltage Range @ RCA Inputs
0.3-8 V RMS
Input Impedance
7 kΩ
Remote Level Control
-
Remote Level Modes
-
Channel Input Mode Switch
-
Pass-through Preamp Output
-
Source Channel Selection for PreOuts
-
Amplifier Filters
Bass Boost EQ
0 to +9 dB (Zone 3 only)
Output Polarity Switch
-
Filter Mode(s) Channels 1 & 2
Low-Pass, High-Pass or Full Range
Filter Slope(s) Channels 1 & 2
-
Filter Frequency Range Channels 1 & 2
32 Hz-320 Hz
Filter Mode(s) Channels 3 & 4
Low-Pass, High-Pass or Full Range
Filter Slope(s) Channels 3 & 4
-
Filter Frequency Range Channels 3 & 4
32 Hz-320 Hz
Filter Mode(s) Channels 5 & 6
Low-Pass, High-Pass or Full Range
Filter Slope(s) Channels 5 & 6
-
Filter Frequency Range Channels 5 & 6
32 Hz-320 Hz
High-Pass/Low-Pass Full Range Filter
-
HP Variable Crossover Frequency Range
-
LP Variable Crossover Frequency Range
-
Infrasonic Filter
-
Detented, Calibrated Filter Potentiometers
-
Electrical
Operating Voltage
10.8-16 VDC
Current Consumption (idle)
-
Current Consumption (standby)
-
Fuse Rating
3 x 40 A ATC blade-type (SAE J1171)
Recommended Fuse Type(s)
-
Minimum Copper Power/Ground Wire Gauge
-
General
Water/Dust Protection Rating
-
Operating Temperature Range
32° to 122° F (0° to 50° C)
Protection Circuits
-
Warranty/Certifications
Certifications
-
Warranty
3 Years