Dimensions
Dimensions (H x W x D)
-
Weight
-
Amplifier
Amplifier Class
Class D
Channels
5
Amplifier Power
Rated Continuous (RMS) Power (Manufacturer Rating @ 4 Ohm)
Main: 50 W x 4/150 W x 2 (Bridged)/Sub: 200 W x 1
Rated Continuous (RMS) Power (Manufacturer Rating @ 2 Ohm)
Main: 75 W x 4/Sub: 300 W x 1
Amplifier Processing
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
≥ 70 dB
Signal-to-Noise Ratio (Manufacturer Rating)
-
Damping Factor @ 4 Ω
-
Damping Factor @ 2 Ω
-
THD+N @ rated power
-
Frequency Response (+0, -1dB)
Channels 1-4: 10 Hz-20 kHz; Channel 5: 10 Hz-250 Hz
Input Voltage Range @ RCA Inputs
200 mV-4 V (low level); 600 mV-10 V (high level)
Input Impedance
22 kΩ (RCA); 470 Ω (speaker level)
Remote Level Control
-
Remote Level Modes
-
Channel Input Mode Switch
-
Pass-through Preamp Output
-
Source Channel Selection for PreOuts
-
Amplifier Filters
Bass Boost EQ
-
Output Polarity Switch
-
Filter Mode(s) Channels 1 & 2
-
Filter Slope(s) Channels 1 & 2
-
Filter Frequency Range Channels 1 & 2
-
Filter Mode(s) Channels 3 & 4
-
Filter Slope(s) Channels 3 & 4
-
Filter Frequency Range Channels 3 & 4
-
Filter Mode(s) Subwoofer Channel
-
Filter Slope(s) Subwoofer Channel
-
Filter Frequency Range Subwoofer Channel
-
High-Pass/Low-Pass Full Range Filter
-
HP Variable Crossover Frequency Range
-
LP Variable Crossover Frequency Range
-
Infrasonic Filter
-
Detented, Calibrated Filter Potentiometers
-
Electrical
Operating Voltage
-
Current Consumption (idle)
-
Current Consumption (standby)
-
Fuse Rating
-
Recommended Fuse Type(s)
-
Minimum Copper Power/Ground Wire Gauge
-
General
Water/Dust Protection Rating
IP65
Operating Temperature Range
-
Protection Circuits
-
Warranty/Certifications
Certifications
-
Warranty
2 Years